I've tried slowly turning on the tank valve waiting a bit before lighting the grill, but the flame is still too low. I'll have to wait til summer before I can use the 20# tank with adapter hose again.
EDIT: After trying the procedure below I'm up and cooking again with full force even with it being 35 degress outside.
BYPASS INSTRUCTIONS
GAS GO ANYWHERE, WEBER Q + BABY Q
Since 1995, all regulators on gas barbecues have a safety device which restricts the gas flow in the event of a gas leak. You can inadvertently activate the safety device without having a gas leak. Typically, this occurs if you open the LP tank valve too rapidly, or if the valve + regulator assembly is in a slightly open position when opening the LP tank valve.
Your must remember when you are grilling you should always do the tank valve first and then the valve + regulator assembly when you start grilling or stop grilling. Never turn off the valve + regulator assembly before the tank. Gas is trapped in the valve + regulator assembly and adapter hose and the next time you turn on the tank, that residual gas in the line will back up and trigger the safety device.
Also, when you start grilling, you should open the tank valve V-E-R-Y S-L-O-W-L-Y, about ¼ turn at a time until it is all the way open before you turn on your valve + regulator assembly to light the grill even is it takes 30 seconds to a full minute. If you've just had your tank refilled, it has a lot more pressure in it at first than after you use it for awhile. That may trigger the safety device sometimes, too. These conditions can be recurring. If it happens again, then you will need to go through the reset procedure again.
If you do activate the gas regulator safety device, the barbecue will only reach temperatures between 250 and 300 degrees, even with the valve + regulator assembly on the HIGH setting.
TO RESET THE GAS REGULATOR SAFETY DEVICE:
Open the barbecue lid.
1. Close the LP tank valve.
2. Turn valve + regulator assembly to the OFF position.
3. Wait at least 5 minutes if the barbecue had been lit
4. Disconnect the adapter hose from the LP tank.
5. Turn valve + regulator assembly to the HIGH position.
6. Wait at least 2 minutes, then turn valve + regulator assembly to the OFF position.
7. Re-connect the adapter hose to the LP tank.
RE-LIGHTING THE BARBECUE:
Open the barbecue lid.
1. SLOWLY open the LP tank valve 1/4 turns at a time all the way open.
2. With the lid open, turn valve + regulator assembly to the HIGH position.
3. Ignite the grill by pushing the crossover ignition button.
4. After the burner is lit, close the lid.
5. The barbecue should reach 500 to 550 degrees in 10-15 minutes.
WHEN YOU ARE DONE GRILLING:
Turn off the LP tank valve first
Turn valve + regulator assembly to the OFF position.
If you continue to have problems or questions, please refer to the "Support" section on our website at www.weberbbq.com and look under "gas grills FAQS" or "charcoal grills FAQS" or call us.I bought the Charbroil Model#4623 46" adapter hose from Home Depot for $17 (also at Lowe's @ same price). It is the same hose as Weber but much cheaper. I matched both hoses together and both were identical down to the tags and warnings, the only difference was the packaging and price. The hose works well with 20 lb LP tanks and last way longer than the 14.1oz tanks.
Buy Weber 41455 20 Pound Tank Adapter Hose for Use with Weber Q and Go-Anywhere Gas Grill Now
I'm very pleased that I purchased the 20 lbs tank adapter hose for my Weber Q grill. The Q is our primary grill. We've always used portable grills in this way, but we love the Q so well, we use it much more than other portables we've owned. Also, the Q takes the smaller 14.1 ounce propane tank normally used for torches rather than the 16 ounce camping tanks. It really didn't make practical and economic sense to keep using the small tanks on a grill with the Q's capacity. But still I purchased this item with some trepidation. I'd read AMAZON reviews reporting that squirrels will eat through the grease splattered hose. My property is in an Oak & Hickory grove, so I have squirrels in over abundance. These guys have been known to augment their diets with my garden plants, but gnawing greasy hose sounds much more like mouse & rat behavior. I took a chance. So far no trouble. I'm using a homebuilt grill table with a 2 X 3 granite top and a generic grilltofloor length vinyl grill cover. (The weber Q cover only encloses the top of the grill) These might be a factors. A little Capsaicin , (the element in peppers that makes them hot, fond in products like "Squirrel Away"), might help the folks with gnawing issues. The 4" hose is quite long enough to reach from the grill port, under the table to my tank with ease and installation is very simple. I bought the adapter and my very first 20 lbs propane tank the same day and I was grilling that evening. I do agree that it would only improve the adapter if the hose were enclosed in say, metal mesh. But that would undoubtedly increase the price. I think at the current price point the 20 pound hose adapter is a great addition that grants me more use and enjoyment of a great grill. I still think it was worth the risk of rodent interference to get this adapter compared to the cost of 14.1 ounce propane tanks over time. But I admit to hedging my bet, If the hose gets oily, I'm keeping a shaker of cayenne pepper handy to sprinkle on it just in case.....2011 Follow up to my earlier review:
After several years of good use, my adapter hose was finally taken out by rodents during winter storage. Fortunately, someone out there listened and in March of 2010, I was able to purchase a stainless steel adapter hose
http://www.amazon.com/gp/product/B000THEZR8/ref=wms_ohs_product_T2
I used the stainless hose for a year have been very pleased with it. The hose fit the tank and grill ends fine and is a good length to reach from grill to tank. Just this month I replaced my Weber Q with a Weber genesis 320. (The Q still works great, but I wanted more BTUs.) The new grill has its own hose which is enclosed in a cabinet, so I'm not too worried about grease spills. I am however, hanging on to the stainless hose just in case the rodents get restless again. It looks like the hose I purchased is no longer available at the link above, but an Amazon search on "Freedom Grill FG-50HA Stainless Steel Propane Hose Adapter", brings up some other brands that might be worth checking out.Works great. Be sure to wait the prescribed time (~ 1 minute) after opening the valves otherwise the supply is reduced to pilot lite strength. I speak from experience. Duh.
Want Weber 41455 20 Pound Tank Adapter Hose for Use with Weber Q and Go-Anywhere Gas Grill Discount?
Excellent product, however, the directions are not clear as to proper hook up. Once the adapter is connected, you should turn on the propane tank and wait at least 5 minutes before igniting the grill. This step ensures that enough pressure builts in the regulator(the round thing on the side of the grill) and will produce a strong flame.
No comments:
Post a Comment